Konica-minolta Magicolor 5440 DL Manuel d'utilisateur Page 1

magicolor 5440 DL/ magicolor 5450 Warranty Exchange Guide®1760678-001B

Prepare the Original Printer8Original4 Remove the waste toner bottle.Original5 Dispose of the used waste toner bottle in accordance with your local r

Move the Consumables 9Move the ConsumablesToner CartridgesOriginal1 Remove all four toner cartridges from the original printer.Exchange2 Partially ins

Move the Consumables10Transfer Belt UnitExchange3 Slide the waste toner bottle out about 4" (10 cm) in order to install the transfer belt unit l

Move the Consumables 11Original2 Remove the left side cover.Original3 Open the right side cover, and then use a coin to loosen the two screws securing

Move the Consumables12Original5 On the right side of the printer, tighten the two screws again, and then close the cover. Original6 Attach the printe

Move the Consumables 13Exchange8 Using a coin, remove the three screws on the exchange printer’s left side cover.Exchange9 Remove the left side cover.

Move the Consumables14Exchange11 From the left side of the printer, carefully slide in the transfer belt unit.!" If you can’t easily slide in th

Move the Consumables 15Exchange14 Slide the waste toner bottle and four toner cartridges completely into the printer, and then close the printer’s fro

Move the Options (If Necessary)16Move the Options (If Necessary)Duplex OptionOriginal1 Remove the duplex option.Original2 Replace the pieces on the o

Move the Options (If Necessary) 17Lower Feeder Unit(s)Original1 Prepare the lower feeder unit(s) for moving.ABC DE F

TrademarksKONICA MINOLTA and the KONICA MINOLTA logo are trademarks or registered trademarks of KONICA MINOLTA HOLDINGS, INC.magicolor is a trademark

Move the Options (If Necessary)18Original2 With the help of another person, lift the printer by its carrying grips, and place it on a flat surface.WA

Move the Power Cord and Interface Cables 19Move the Power Cord and Interface CablesExchange1 Plug the power cord into the exchange printer and into an

Repack the Original Printer20Repack the Original PrinterOriginal1 Install the fuser separators.ABCD

Repack the Original Printer 21Original2 Replace the tape and packaging inside Tray 1.ABCDE

Repack the Original Printer22Original3 Replace the tape on the outside of the printer.ABC

Repack the Original Printer 23Original4 Repack the original printer in the carton in which the exchange printer was shipped.Original5 Securely tape th

Introduction 1IntroductionThank you for contacting a technical support representative to obtain information about returning your magicolor 5440 DL/mag

Unpack the Exchange Printer2Unpack the Exchange PrinterAttentionUse caution when unpacking the exchange printer, so the packaging can be used to repa

Unpack the Exchange Printer 3Exchange3 Remove the tape and packing material from the inside of the exchange printer.Exchange4 Remove the fuser separat

Unpack the Exchange Printer4Exchange5 Unpack and install the Manual Feed Tray.AC DEFB

Unpack the Exchange Printer 5Exchange6 Remove the tape and packing materials from Tray 1.Exchange7 Load media in Tray 1.Exchange8 Unpack and install t

Prepare the Original Printer6Prepare the Original PrinterOriginal1 Turn off the original printer, unplug the power cord, and remove the interface cab

Prepare the Original Printer 7Original3 Remove the manual feed tray.A BC DE F