Konica-minolta bizhub PRESS C6000 Manuel d'utilisateur télécharger pdf (Page 7)

Page 7 of 7

Part Number: 45097576

Error messages

One of the following error messages may display on the Control Panel when you attempt to

perform the upgrade. If an error condition cannot be corrected, restore the previous

configuration, if possible, and contact your authorized service/support center.

Error message Cause and solution

BIOS already enabled. Press OK to reboot. The BIOS has already been upgraded to

version 1.55. Remove the dongle and BIOS

upgrade CD, and proceed to install system

software (see page 4).

Product mismatch. Press OK to reboot. You are attempting to perform the BIOS

upgrade on an invalid system. Make sure that

you are performing the upgrade on a

Fiery PRO

80C-KM or Fiery PRO

70-60C-KM Color Server.

No uses remaining One of the following:

•The dongle has already been used and cannot

be reused. Obtain an unused dongle.

• The dongle is missing or improperly

attached. Attach the dongle securely to the

Fiery PRO

Invalid dongle found! Please remove dongle

and connect the correct dongle

One of the following:

• The attached dongle is not valid. The dongle

may have been attached by mistake. Obtain a

valid dongle and try again.

• More than one dongle is attached to the

Fiery PRO

. The BIOS upgrade cannot

proceed when multiple dongles are attached

to the system. Remove all dongles except the

correct dongle, and try again.

Updating BIOS. Do not shut down! This is a normal status message indicating that

the BIOS upgrade is in process.

However, if this message persists for longer

than 10 minutes, the BIOS upgrade has failed

due to a faulty system component. Refer to the

Fiery PRO

Installation and Service Guide for

information on troubleshooting the faulty

component.

DVD does not support platform! Press OK to

reboot.

You are attempting to install version 2.0 of

system software on a Fiery PRO

that does not

have BIOS version 1.55. First perform the

BIOS upgrade (see page 3), and then try

installing system software again.

1 2 3 4 5 6 7

Commentaires sur ces manuels

Pas de commentaire

Konica-minolta bizhub PRESS C6000 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimeurs Konica-minolta bizhub PRESS C6000