Konica-minolta DiMAGE S404 Manuel d'utilisateur télécharger pdf (Page 61)

BULB EXPOSURES

Bulb photographs can be taken in the manual-exposure mode (M) (p. 53). Exposures up to fifteen

seconds can be made by pressing and holding the shutter-release button. The use of a tripod is

recommended for bulb exposures.

To set the aperture value, press the exposure-compensation button (2); the aperture display should

turn blue. Use the controller (1) to set the aperture.

• The camera’s exposure system cannot be used to calculate bulb exposures. The use of a separate light

meter is recommended.

Use the controller (1) to decrease the shutter-speed value below

four seconds until “bulb” is displayed.

To take the picture, press and

hold the shutter-release button

(3) for the duration of the expo-

sure.

• Releasing the shutter button will

end the exposure.

• The monitors will be blank during

the exposure.

Set the exposure mode to manual in the basic section of the multi-

function recording mode menu (p. 50). Set the drive mode to

single-frame advance (p. 32).

When making bulb exposures, noise can be more pronounced

because of the unusually long exposure times, especially at 400

ISO. When making long bulb exposures, a camera sensitivity set-

ting of 64 or 100 will produce excellent results. At higher ISO set-

tings, using shorter exposure times (8 seconds or less) will reduce

the effect of noise.

CAMERA NOTES

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 115 116

Pas de commentaire

Konica-minolta DiMAGE S404 Manuel d'utilisateur Page 61