Konica-minolta Polygon Editing Tool Manuel d'utilisateur télécharger pdf (Page 94)

Chapter

File

900

910

File – Import – Digitizer – Step Scan (When VIVID 900/910 is Selected)

Enter the desired element name, and

set parameters.

• Select the desired rate from “1/1”, “1/4”, “1/9”,

“1/16” and “No polygon” by selecting from the

[Reduction Rate] pull-down menu.

• If you want to generate points to ll in holes

caused by missing data, set the [File Holes] set-

ting to “On”.

• The [Remove] pull-down menu lets you select

which points to remove from the imported data.

You can set this to any of the following: “None”,

“Boundary(B.)”, “5deg. & B.”, “10deg. & B.”,

“15deg. & B.”, or “20deg. & B.”

• If you want to lter the imported data, select the

appropriate parameter from the [Filter] pull-down

menu.

• If you want to save the raw scan data (.cdm) when

importing, check the [Save CDM] checkbox.

Note

Theelementnamemustconsistofupto31alphanu-

mericcharacters.

In the [General] tab, click the [Go] but-

ton.

The [File-Import-Digitizer-Step Scan-Convert]

dialog box will appear.

Note

Ifnochartdataexistsortheexistingchartdatadoesnot

matchthemeasurementconditions,thefollowingerror

messageswillappear.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 269 270

Pas de commentaire

Konica-minolta Polygon Editing Tool Manuel d'utilisateur Page 94