Konica-minolta DiMAGE X Manuel d'utilisateur télécharger pdf (Page 65)

Connecting the camera to a computer

Start up the computer.

• The computer must be turned on before connecting the camera.

Insert the memory card into the camera.

• Confirm that the correct card is in the camera. To change the memory card while the camera is

connected to a computer, see page 71.

Attach the other end of the USB

cable to the computer’s USB

port.

• Make sure the plug is firmly

attached.

• The camera should be

connected directly to the

computer’s USB port.

Attaching the camera to a

USB hub may prevent the

camera from operating

properly.

A fully charged battery should be used when the camera is connected to a computer. The use of the

AC adapter (sold separately) is recommended over the use of the battery. For users with Windows

98, 98SE, or Mac OS 8.6, read the respective sections on how to install the necessary USB driver

before connecting the camera to a computer (Windows 98 - p. 67, OS 8.6 - p. 70).

Remove the USB-port cover. Attach the smaller plug of the USB cable to the camera.

• Make sure the plug is firmly attached.

• The USB-port cover is attached to the body to prevent loss.

(Continued on the next page)

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 87 88

Pas de commentaire

Konica-minolta DiMAGE X Manuel d'utilisateur Page 65