Konica-minolta bizhub 181 Manuel d'utilisateur Page 137
- Page / 322
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
4
Making copies
4-44 bizhub 181
Making copies Chapter 4
5 Use the keypad to type in “250” for the length (X), and then press the
[OK] key.
– The paper length (X) can be set between 5-1/2 inch (140 mm) and
17 inch (432 mm).
Refer to the diagram at
the right and be sure to
specify the paper width
and length measure-
ments correctly.
6 Use the keypad to type in “180” for the width (Y), and then press the
[OK] key.
– The paper width (Y) can be set between 3-1/2 inch (90 mm) and 11-
3/4 inch (297 mm).
The BYPASS PAPER SETTING menu appears again.
length (X)
width (Y)
- User’s Guide 1
- Introduction 2
- Contents 4
- 3 Before making copies 6
- 4 Making copies 6
- 5 Advanced copy operations 7
- 7 When a message appears 10
- 8 Troubleshooting 10
- 9 Appendix 10
- 10 Index 11
- Available copy features 12
- Book separation copying 13
- Reduced/full-sized/enlarged 13
- Grouping 14
- Crisscross sorting 14
- Crisscross grouping 14
- Negative/positive inverting 15
- Page margins 15
- Mixed document widths 15
- Legal restrictions on copying 20
- Installation and operation 22
- 1.1 Safety information 23
- 7 WARNING 30
- 7 ADVARSEL 33
- 7 VAROITUS 33
- 7 VARNING 33
- 7 ADVARSEL! 34
- 7 ATTENTION 35
- 1.3 Installation precautions 37
- Precaution 42
- 2 Precaution 43
- Precaution Chapter 2 44
- 22 23 24 2625 54
- 2.4 Power supply 58
- 5 Press the [OK] key 64
- Before making copies 66
- 3.2 Copy/print area 71
- 3.3 Paper storage 72
- 3.4 Loading paper 73
- 1 Pull out the 1st paper 74
- 2 Press down on the pa 75
- 3 Load the paper into the 75
- 4 Slide the paper guides to 76
- 5 Close the 1st paper 76
- 1 Pull out the drawer 77
- 5 Close the paper drawer 79
- 3.5 Original documents 80
- 1 Slide apart the adjusta 83
- 2 Load the document so 83
- 3 Slide the document 84
- 2 Position the document 85
- 3 Place a blank sheet of 87
- 2 Place the book on the 88
- 3-24 bizhub 181 89
- 4 Press the [Mixed Origi 91
- 5 Press the [Paper] key 92
- 7 Press the [Start] key 92
- 3-28 bizhub 181 93
- Making copies 94
- 2 Press the [Quality] key 100
- 5 Press the [Start] key 101
- 2 Press the [Density] key 102
- 2 During copying, press 104
- 2 Press the [Paper] key 105
- Making copies Chapter 4 106
- 2 Insert one sheet of paper 120
- 3 Slide the paper guides to 120
- 8 Select “RETURN” 122
- 10 Press the [Start] key 122
- 2 Load the paper with the 123
- 3 Adjust the tray extension 123
- 3 Press the [Utility] key 127
- 12 Press the [Start] key 129
- 14 Press the [Paper] key 134
- 16 Press the [Start] key 134
- 11 Press the [Start] key 143
- 4.6 Specifying a Zoom setting 144
- 2 Press the [Zoom] key 145
- 6 Press the [Start] key 147
- 2 Press the [Function] key 150
- 7 Press the [Back] key 151
- 9 Press the [Start] key 151
- 1 Press the [Interrupt] key 155
- 1 With the main screen 157
- 4 Press the [OK] key 158
- 5 Press the [Back] key 158
- Advanced copy 160
- NON-SORT 161
- 1 Load the document into 164
- 2 Press the [Finishing] key 164
- 2 Position the first page of 166
- 3 Press the [Finishing] key 166
- 8 Press the [Start] key 167
- 3 Press the [Combine 169
- 2 Press the [Combine 171
- PATTERN1 PATTERN2 172
- 1 Position the first page of 175
- 2 Press the [Simplex/Du 175
- LEFT ERASE 182
- UPPER ERASE 182
- FRAME ERASE 182
- Left binding 187
- 2 Press the [Mode Memo 190
- 2 Press the [Access] key 194
- 4 Press the [Start] key 194
- Advanced copy operations 195
- 5-36 bizhub 181 195
- Utility mode/Copy mode 196
- 6.1 Utility mode 197
- 6.3 MACHINE SETTING 200
- 1 Press the [Utility] key 201
- 6.4 PAPER SOURCE SETUP 213
- Reminder 228
- 6.7 ADMIN. MANAGEMENT 229
- 6.8 COPY SETTING 1 247
- 6.9 COPY SETTING 2 262
- SF-501 is installed 270
- 6-76 bizhub 181 271
- When a message appears 272
- 1 Open the front door 274
- 2 Open the toner bottle 274
- 3 While holding the sealed 275
- 4 With the side of the toner 275
- 5 Lightly tap the bottom of 276
- 6 Close the toner bottle 276
- 7 CAUTION 278
- 1 Open the right-side door 278
- 2 Pull down the fusing unit 279
- 3 Slowly pull out the pa 280
- 4 While holding the guide 280
- 5 While turning the knob 281
- 6 Close the right-side door 281
- 7 Pull out the 1st paper 282
- 8 Remove all paper from 282
- 9 Slide the paper guides to 283
- 10 Close the 1st paper 283
- 1 Open the right-side 284
- 2 Slowly pull out the pa 284
- 3 Close the right-side 285
- 4 Pull out the paper draw 285
- 5 Remove all paper from 286
- 6 Slide the paper guides to 286
- 7 Close the paper drawer 287
- 1 Remove all paper from 288
- 2 Open the right-side door 288
- 4 Close the right-side door 290
- 5 Reload paper into the 290
- 1 Open the duplex unit 291
- 2 Carefully pull out any 291
- 3 Close the duplex unit 292
- 1 Open the misfeed-clear 293
- 2 Remove all document 294
- 3 Lift open the document 294
- 4 While turning the knob 295
- 5 Close the document 295
- 6 Reload the tray with the 296
- Troubleshooting 300
- Troubleshooting Chapter 8 302
- Appendix 304
- Appendix Chapter 9 306
- 9.2 Care of the machine 310
- Index Chapter 10 318
- Printed in China 322
- A08E-9551-00 322
Produits connexes et manuels pour Matériel Konica-minolta bizhub 181
(92 pages)
(352 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.447 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels